Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
8Y

Boiler blocked by an external contact

Blocking: it retries by itself

An external contact connected to the boiler is open and is blocking the burner: depending on the model, an external thermostat or temperature limiter, a failed condensate pump, an external blocking terminal or a solid fuel boiler in operation. This is a blocking fault: the boiler restarts by itself as soon as the contact closes again.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show 8Y?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code 8Y

The small number shown beside the code tells which.

8Y
232

The AT90 temperature controller has tripped / AT90 temperature controller faulty / The jumper on the connection terminals for the…

Blocking: it retries by itself GB072, GB162, GB172, GB172i
8Y
572

External lock via connection terminal EV 1,2

Blocking: it retries by itself KB195i, KB195i.2
8Y
583

External lock of the switching module

Blocking: it retries by itself GB212, KB192i, KB195i

The boilers that show this code

What our technician checks

  • The external switch contact, and the jumper across its terminals if no contact is connected
  • The setting of the external thermostat (AT90, TB 1) and of the heating controls
  • The sensor of this thermostat and its cable (open circuit, short circuit), replaced if necessary
  • The external temperature limiter, to be reset
  • The condensate drain and the condensate pump, replaced if necessary
  • The cable and the external blocking terminal EV 1,2 (KB195i, KB195i.2)
  • The voltage at the external contact of the UM10 module (KB195i)

The same fault on other boilers

Recent boilers show alone the number older ones show beside the code.

232

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.