No flame at ignition
Breakdown: the boiler is stopped
The boiler tries to light its burner and does not detect a flame. After several attempts, it goes into safety mode and stops heating.
What you can do
- Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
- Check that the boiler's gas shutoff valve is open.
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show 6A?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a real expert
Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.
The variants of code 6A
The small number shown beside the code tells which.
Flame not detected
No flame during the safety time
No flame during the safety time
The boilers that show this code
What our technician checks
- The gas shutoff valve, the supply pressure and purging of the gas line
- The electrical connection: ground, line and neutral
- The ignition and the ionization current, measured with a microammeter
- The ignition and monitoring electrodes, their cables and connectors
- The flue and the air supply
- The air-gas ratio of the burner
- The condensate trap, dirt buildup in the heat exchanger, and the gas valve