Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
F67

Calibration value stored incorrectly

Breakdown: the boiler is stopped

The base value of the combustion (SCOT) calibration was stored incorrectly, on a WTC-GW or WTC-GB B series boiler or a Thermo Condens WTC-A; too low a gas pressure or a wrong gas type setting can be the cause. The boiler locks out and stops heating until our technician has checked the gas and redone the calibration.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F67?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F67

The meaning depends on the boiler: find yours below.

F67

SCOT base value save error

Breakdown: the boiler is stopped WTC-GW/GB B (WEM)
F67

Setpoint incorrectly saved

Breakdown: the boiler is stopped Thermo Condens WTC-A (WCM)

What our technician checks

  • The gas connection pressure
  • The gas type setting (P11 on the WTC-A)
  • A calibration through the final measurement
  • The boiler electronics if the fault keeps coming back

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.