Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
F21

No flame when the burner starts

Breakdown: the boiler is stopped

At start-up the burner fails to form a flame: on gas on a WTC-GW or WTC-GB B series boiler and on a Thermo Condens WTC-A (which gives up after 5 ignition attempts), on oil on a WTC-OB boiler. The boiler then locks out and stops heating; on a WTC-GW or WTC-GB B series boiler the same code can also point to a fault in the controller of a connected solar module, unrelated to the burner.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F21?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F21

The meaning depends on the boiler: find yours below.

F21

Combustion manager: No flame formation when the burner starts / Solar EM: Differential controller fault

Breakdown: the boiler is stopped WTC-GW/GB B (WEM)
F21

No flame formation at start-up

Breakdown: the boiler is stopped Thermo Condens WTC-A (WCM)
F21

No flame formation when the burner starts

Breakdown: the boiler is stopped WTC-OB (WCM-OB)

What our technician checks

  • The gas supply: connection pressure, gas valve and its cable, maximum gas pressure switch
  • The ionisation electrode, the ignition electrode and its cable
  • The ignition unit (ignition transformer on the WTC-OB)
  • The burner, to be cleaned, and the cleanliness of the combustion air
  • The flame formation time and the gas setting at ignition
  • The tightness and clear passage of the flue, and the condensate drain
  • On the WTC-OB: the oil supply and pump, the solenoid valves, the nozzle and the flame sensor
  • With a solar module (WTC-GW, WTC-GB B series): the control differential between sensors T2 and T3

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.