Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
F60

Calibration too low or data error

Breakdown: the boiler is stopped

On a WTC-GW or WTC-GB B series boiler, the calibration of the SCOT system, which controls combustion through the ionisation electrode, gives a base value that is too low; on a WTC-OB oil boiler, the data were not transferred correctly to the boiler electronics. The boiler locks out and stops heating until our technician has redone the calibration or the data transfer.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F60?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F60

The meaning depends on the boiler: find yours below.

F60

Calibration: SCOT base value too low

Breakdown: the boiler is stopped WTC-GW/GB B (WEM)
F60

Data transmission error of the WCM-OB-CPU boiler electronics

Breakdown: the boiler is stopped WTC-OB (WCM-OB)

What our technician checks

  • A calibration through the final measurement (WTC-GW, WTC-GB)
  • The ionisation electrode and its cable
  • The data transfer from the coding key to the WCM-OB-CPU board (WTC-OB)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.