Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Vaillant Fault code Vaillant
S.76

Water pressure too low, top up

Blocking: it retries by itself

The water pressure in the heating circuit is too low and the boiler shows a maintenance message: it is not yet in fault. Topping up the water is usually enough; if the pressure drops further, the boiler stops for safety (code F.22).

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check the water pressure (display or gauge): below 0.8 bar, top up the heating water as your installer showed you.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show S.76?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code S.76

The meaning depends on the boiler: find yours below.

S.76

Maintenance Check water pressure

Blocking: it retries by itself VC /8-5, VCW /5-3, VCW /5-5, VCW /5-7
S.76

System pressure too low

Blocking: it retries by itself VCC /4

The boilers that show this code

What our technician checks

  • The system pressure, with a top-up
  • The cause of frequent pressure drops

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.