Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Vaillant Fault code Vaillant
S.350

Back-up heater overheat cut-out open

Blocking: it retries by itself

On a flexoTHERM exclusive or flexoCOMPACT exclusive heat pump, status code S.350, shown on the heat pump display, reports that the overheat cut-out of the electric back-up heater has opened: the heating circuit temperature went over its limit and the cut-out switched the back-up heater off. The back-up heater tries again after a waiting time; if the code stays on or comes back, our technician must find the cause.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show S.350?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Vaillant

Choose a recognised installer

Ecowatt is a Vaillant installer: our group is on Vaillant's official list of installers.

The variants of code S.350

The meaning depends on the boiler: find yours below.

S.350

El. backup heater: overheat. prot. open

Blocking: it retries by itself flexoTHERM exclusive VWF ../4

What our technician checks

  • Heating circuit pump circulation and the shut-off valves
  • The safety temperature limiter, to be replaced if its fusible link has tripped
  • Unwanted heat input, to be reduced or stopped

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.