Heating water pressure too low
Blocking: it retries by itself
On a flexoTHERM exclusive or flexoCOMPACT exclusive heat pump, status code S.274, shown on the heat pump display, reports that the water pressure in the heating circuit is too low: a leak, an air pocket or a faulty pressure sensor. Below the minimum pressure of 0.5 bar the heat pump stops, and topping up the water is a job for our technician.
What you can do
- Write down the code shown and the heat pump model (on the rating plate).
- Read the heating water pressure on the display (Menu, System monitor). To top up the water, call us.
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show S.274?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code S.274
The meaning depends on the boiler: find yours below.
Building circuit: pressure too low
What our technician checks
- The heating circuit, for leaks
- Topping up the water and bleeding the circuit
- The pressure sensor, its plug-in contact and the harness, replaced if needed