Brine circuit pressure switch open
Blocking: it retries by itself
On a flexoTHERM exclusive or flexoCOMPACT exclusive heat pump, status code S.265, shown on the heat pump display, reports that the pressure switch of the brine circuit has opened: the pressure in that circuit is too low or the switch no longer sees it. It is a status code that reports an abnormal condition: if the code stays on or comes back, our technician must find the cause, as for fault F.787 of the same name.
What you can do
- Write down the code shown and the heat pump model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show S.265?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code S.265
The meaning depends on the boiler: find yours below.
Environment circuit: pressure switch open
What our technician checks
- The brine circuit for leaks, topping up and bleeding
- The pressure switch, replaced if needed
- The screw contact on the circuit board and the wiring between X110B, X110 and X110A
- Fuse T4
- Mains voltage fluctuations