Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Vaillant Fault code Vaillant
S.263

Fan module 2 air inlet too hot

Blocking: it retries by itself

On a flexoTHERM exclusive or flexoCOMPACT exclusive heat pump that uses outdoor air as its heat source, status code S.263, shown on the heat pump display, reports that the air entering fan module 2 is too hot. The heat pump is then outside its operating limits and its safety devices may stop it while this lasts; if the code stays on or comes back, our technician needs to step in.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show S.263?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code S.263

The meaning depends on the boiler: find yours below.

S.263

Vent. module 2: air inlet temp. too high

Blocking: it retries by itself flexoTHERM exclusive VWF ../4

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.