Brine pump fault signal
Blocking: it retries by itself
On a flexoTHERM exclusive or flexoCOMPACT exclusive heat pump, status code S.247, shown on the heat pump display, reports that the fault contact of the brine circuit pump is open: the pump's electronics have detected a problem, for example dry running or a blockage. It is a status code that reports an abnormal condition: if the code stays on or comes back, our technician must check the pump and the circuit, as for fault F.715 of the same name.
What you can do
- Write down the code shown and the heat pump model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show S.247?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code S.247
The meaning depends on the boiler: find yours below.
Environment circuit: pump fault contact open
What our technician checks
- The pump's operation and its plug-in contact, after switching off the power for at least 30 seconds
- Bleeding the brine circuit
- The brine mix, checked with a refractometer
- The dirt filter, the strainer and the air separator