Brine circuit pressure too low
Blocking: it retries by itself
On a flexoTHERM exclusive or flexoCOMPACT exclusive heat pump, status code S.246, shown on the heat pump display, reports that the pressure in the brine circuit, the circuit that collects heat from the source, is too low: a leak, an air pocket or a faulty pressure sensor. Below the minimum pressure of 0.5 bar the heat pump stops, and topping up the brine is a job for our technician.
What you can do
- Write down the code shown and the heat pump model (on the rating plate).
- Read the brine circuit pressure on the display (Menu, System monitor). To top up the brine, call us.
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show S.246?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a recognised installer
Ecowatt is a Vaillant installer: our group is on Vaillant's official list of installers.
The variants of code S.246
The meaning depends on the boiler: find yours below.
Environment circuit: pressure too low
What our technician checks
- The brine circuit, for leaks
- Topping up the brine and bleeding the circuit
- The pressure sensor, its plug-in contact and the harness, replaced if needed