Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Vaillant Fault code Vaillant
M.200

Low glycol pressure in heating circuit

Information: nothing to do

On a Vaillant aroTHERM VWL ../5 AS, aroTHERM plus VWL ../6 A, versoTHERM plus or recoCOMPACT exclusive heat pump, the controller reports low water-glycol pressure in the heating circuit, because of a leak, an air pocket or a faulty pressure sensor. This is a maintenance message: the heat pump is not in fault mode and keeps running normally, but the circuit must be checked by our technician.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. This message calls for a visit from our technician: call us to plan it.

Nothing to do

This message belongs to the boiler's normal operation.

Call us
Vaillant

Choose a recognised installer

Ecowatt is a Vaillant installer: our group is on Vaillant's official list of installers.

The variants of code M.200

The meaning depends on the boiler: find yours below.

M.200

Heating circ. brine pressure low

Information: nothing to do aroTHERM VWL ../5 AS, aroTHERM plus VWL ../6 A, recoCOMPACT exclusive VWL ../5, versoTHERM plus VWL ../5

What our technician checks

  • The heating circuit's tightness, topping up and venting
  • The pressure sensor, its plug on the circuit board and the wiring harness, replaced if necessary

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.