Heating water pressure sensor fault
Breakdown: the boiler is stopped
On an aroTHERM pure, aroTHERM Split plus, aroTHERM pro or aroTHERM plus VWL ../8.1 (with or without iQconnect) heat pump, the signal of the heating circuit water pressure sensor is not valid: the sensor is not connected or its input is short-circuited. The heat pump goes into fault mode and stops until our technician has fixed the cause and restarted it.
What you can do
- Write down the code shown and the heat pump model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F.827?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.827
The meaning depends on the boiler: find yours below.
The signal of the building circuit water pressure sensor is invalid.
What our technician checks
- The water pressure sensor, replaced if needed
- The wiring harness, replaced if needed
- The controller circuit board, replaced if needed