Expansion valve temperature sensor fault
Breakdown: the boiler is stopped
On an aroTHERM, versoTHERM plus or recoCOMPACT exclusive heat pump, the refrigerant circuit temperature sensor at the outlet of the electronic expansion valve, at the evaporator inlet, no longer sends a valid signal: the sensor is faulty, badly connected or short-circuited, or on the aroTHERM VWL ../8.1 A Q the PCB is faulty. This is a fault: the heat pump no longer works normally (depending on the fault, it may keep running in emergency mode) and our technician has to find the cause.
What you can do
- Write down the code shown and the heat pump model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F.526?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.526
The meaning depends on the boiler: find yours below.
Sensor error: EVD temp. environment circuit
Sensor fault: expansion valve outlet temp.
The signal of the evaporator inlet temperature sensor in the circuit
What our technician checks
- The electronic expansion valve temperature sensor, replaced if necessary
- The sensor wiring harness and plug, replaced if necessary
- The sensor connection to the PCB, and the PCB itself