Compressor inverter not detected
Breakdown: the boiler is stopped
On an aroTHERM, versoTHERM plus or recoCOMPACT exclusive heat pump, the control PCB no longer communicates with the compressor's frequency converter (inverter): the connection is damaged or broken, or on the aroTHERM VWL ../2 A, ../3 A the inverter is no longer powered or a parameter is wrongly set. This is a fault: the heat pump no longer works normally (depending on the fault, it may keep running in emergency mode) and our technician has to find the cause.
What you can do
- Write down the code shown and the heat pump model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F.753?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.753
The meaning depends on the boiler: find yours below.
Connection error: transformer not detected
Connection fault: inverter not detected
Communication with the inverter is interrupted.
What our technician checks
- The wiring harness and plug connections between the PCB and the inverter, replaced if necessary
- The inverter, tested by driving the compressor safety relay
- The inverter parameters, which must show values
- The power supply of the inverter box (aroTHERM VWL ../2 A, ../3 A)
- The compressor parameter Max. power cut (aroTHERM VWL ../2 A, ../3 A)
- The PCB, replaced if faulty (aroTHERM VWL ../8.1 A Q)