Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Vaillant Fault code Vaillant
F.742

Brine too warm for compressor start

Breakdown: the boiler is stopped

On a flexoTHERM exclusive or flexoCOMPACT exclusive heat pump, F.742 reports that the brine coming in from the brine circuit (which draws heat from the ground, the outdoor air or the groundwater) is too warm for the compressor to start: above 50 °C, for example because outside heat is being fed into that circuit. The compressor does not start while the temperature stays beyond that limit; if the code stays on, our technician checks the brine circuit, the sensors and the four-way valve.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F.742?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.742

The meaning depends on the boiler: find yours below.

F.742

Environment circuit: inlet temp. too high

Breakdown: the boiler is stopped flexoTHERM exclusive VWF ../4

What our technician checks

  • In heating mode: the four-way valve's operation
  • The brine circuit
  • The sensors
  • Outside heat fed into the brine circuit, to be reduced or cut off

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.