Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Vaillant Fault code Vaillant
F.732

Compressor outlet temperature too high

Breakdown: the boiler is stopped

On a Vaillant aroTHERM VWL ../5 AS, aroTHERM plus VWL ../6 A, aroTHERM pure, aroTHERM Split plus, aroTHERM VWL ../7.1 A and ../8.1 A, aroTHERM VWL ../8.1 A Q, versoTHERM plus, recoCOMPACT exclusive or flexoTHERM/flexoCOMPACT exclusive heat pump, the temperature at the compressor outlet is above 130 °C (110 °C on an aroTHERM plus VWL ../6 A): operating limits exceeded, an electronic expansion valve that does not open properly, a clogged filter in the refrigerant circuit or too little refrigerant. This is a refrigerant circuit fault for a technician to check; depending on the fault, the system may keep heating in emergency mode.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F.732?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.732

The meaning depends on the boiler: find yours below.

F.732

Compr. outlet temp. too high

Breakdown: the boiler is stopped aroTHERM VWL ../5 AS, aroTHERM plus VWL ../6 A, flexoTHERM exclusive VWF ../4, recoCOMPACT exclusive VWL ../5, versoTHERM plus VWL ../5
F.732

Compressor outlet temperature too high

Breakdown: the boiler is stopped aroTHERM Split plus VWL ../8.2 AS, aroTHERM VWL ../7.1 A, ../8.1 A, aroTHERM VWL ../8.1 A Q, aroTHERM pure VWL ../7.2 AS

What our technician checks

  • The compressor inlet and outlet sensors
  • The condenser outlet temperature sensor (TT135)
  • The electronic expansion valve: does it reach its end stop? (sensor and actuator test)
  • The refrigerant quantity (technical data)
  • The tightness of the refrigerant circuit
  • The outdoor unit's service valves, which must be open
  • The low-pressure sensor
  • On an aroTHERM VWL ../8.1 A Q: the temperature difference before and after the refrigerant circuit filter (4 K at most), and the circuit board

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.