Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Vaillant Fault code Vaillant
F.715

Brine circuit pump fault

Breakdown: the boiler is stopped

On a flexoTHERM exclusive or flexoCOMPACT exclusive heat pump, F.715 reports that the brine circuit pump has gone into fault: its electronics detected a problem (dry running, blockage, overvoltage or undervoltage) and switched it off and locked it; air in the circuit or brine that is too viscous can be the cause. It is a fault: the heat pump no longer works normally, and our technician puts it back into operation once the cause is fixed.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F.715?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.715

The meaning depends on the boiler: find yours below.

F.715

Environment circuit: pump fault contact open

Breakdown: the boiler is stopped flexoTHERM exclusive VWF ../4

What our technician checks

  • Switching the heat pump off at the mains for at least 30 seconds
  • The plug contact on the circuit board
  • The pump's operation
  • Bleeding the brine circuit, and the air separator
  • The brine mixing ratio, measured with a refractometer
  • The dirt filter and strainer (fouling)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.