Brine circuit pressure too low
Breakdown: the boiler is stopped
On a flexoTHERM exclusive or flexoCOMPACT exclusive heat pump, F.714 reports that the brine pressure in the brine circuit (which draws heat from the ground, the outdoor air or the groundwater) is too low: a leak, an air pocket or a faulty pressure sensor. Below the minimum pressure (0.5 bar) the heat pump switches off automatically; topping up the brine is a job for our technician.
What you can do
- Write down the code shown and the heat pump model (on the rating plate).
- Read the brine circuit pressure on the heat pump display (System monitor menu, brine circuit pressure). To top up the brine, call us.
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F.714?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.714
The meaning depends on the boiler: find yours below.
Environment circuit: pressure too low
What our technician checks
- Leaks in the brine circuit
- Topping up the brine (or water) and bleeding the circuit
- The plug contacts on the circuit board and the wiring harness
- The pressure sensor, checked and replaced if needed