Hot water outlet sensor fault
Breakdown: the boiler is stopped
The sensor that measures the hot water leaving the storage tank or the boiler no longer gives a valid signal: plug loose, cable broken or sensor faulty. This is a fault: the boiler stops and our technician has to find the cause before putting it back into service.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F.47?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.47
The meaning depends on the boiler: find yours below.
The signal from the domestic hot water temperature sensor at the outlet of the internal cylinder
DHW inlet sensor interruption
DHW sensor open circuit at cylinder outlet (flow detection)
What our technician checks
- The sensor plug and connector
- The wiring harness between the circuit board and the sensor
- The hot water outlet sensor, replaced if faulty