Cylinder temperature sensor disconnected
Breakdown: the boiler is stopped
The boiler no longer receives the signal from the hot water cylinder's temperature sensor (or the preheating sensor on the atmoTEC plus VUW /4-5): the sensor, its cable or a connector is at fault. It is a fault code: the boiler no longer works normally and needs a technician.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F.03?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.03
The meaning depends on the boiler: find yours below.
The signal from the storage temperature sensor is interrupted.
Storage temperature sensor interruption
Open circuit at the storage temperature sensor
Cylinder sensor open circuit
Storage sensor fault
Hot start flow temperature sensor / cylinder sensor interruption (NTC)
Open circuit on the storage temperature sensor/preheating temperature sensor
Cylinder NTC sensor interruption
The boilers that show this code
What our technician checks
- The wiring between the circuit board and the sensor, connectors included
- The cylinder temperature sensor, replaced if needed
- The link to the cylinder electronics
- With a stratified cylinder: connectors, circuit board and harness