Gas valve fault
Breakdown: the boiler is stopped
The gas valve does not respond properly: its stepper motor (or its coil on the atmoTEC plus VUW /5-5) is disconnected or faulty, or the wiring or circuit board is at fault. It is a fault: the boiler can no longer control its gas and does not work normally until a technician has been.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F.26?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.26
The meaning depends on the boiler: find yours below.
Fault §§ fuel valve faulty
Gas valve stepper motor current implausible
Fault: gas valve assembly inoperative
Gas valve stepper motor current not plausible
The boilers that show this code
What our technician checks
- The gas valve stepper motor: connector, cable, coils, voltage
- The multi-pin connector
- The wiring harness
- The stepper motor, replaced if needed
- The circuit board and the ionisation electrode