Heat exchanger overheat fuse tripped
Breakdown: the boiler is stopped
The heat exchanger's overheat protection (fuse) has tripped: the exchanger got too hot through lack of water or pressure, no circulation or too much air in the system, or it is faulty. On the Avanta, Avanta Plus, Avanta Platinum Plus and Aquanta the boiler locks out: it only restarts once the cause is removed and the reset button is pressed.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Check the system water pressure: at least 1 bar. Too low? Top up with water as your installer showed you.
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show E13?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code E13
The meaning depends on the boiler: find yours below.
The heat exchanger fuse protection is activated
The heat exchanger overheat protection has tripped
The heat exchanger melt protection has tripped
What our technician checks
- The plug and wiring of the heat exchanger fuse
- The heat exchanger, replaced only once the cause has been removed
- The water pressure and any leaks
- The circulation pump: shaft freed with a screwdriver, wiring, replaced if faulty
- Bleeding air from the boiler and the system