Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Fault code Oertli
E10

No water flow during a fan cycle

Breakdown: the boiler is stopped

On a GMR 1000 Condens, the water does not circulate during a fan cycle: water level or pressure too low, no circulation, too much air, or a wrongly wired pump. The boiler stops and the code flashes on the display; it only restarts after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check the water pressure on the boiler's pressure gauge: below 1 bar, top up the water as your installer showed you.
  3. Reset the boiler once only.
  4. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show E10?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code E10

The meaning depends on the boiler: find yours below.

E10

No water circulation during a fan cycle

Breakdown: the boiler is stopped GMR 1000 Condens

The boilers that show this code

What our technician checks

  • The system water pressure and any leaks
  • The boiler circulation pump: shaft freed with a screwdriver, wiring, replaced if it does not run
  • Bleeding the boiler, with the pump off
  • The pump's electrical connections

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.