Fan or pressure switch fault
Breakdown: the boiler is stopped
During operation the flue extraction no longer works properly: on a CeraclassExcellence ZWC-3 or a Eurostar ZWE-4 the pressure switch has opened; on a Cerasmart or an older Cerapur the extractor fan turns too slowly; on a Cerapur ZWB-4 (C1 264) the fan has failed. On a Cerapur ZWB-4 it is a blocking fault: the boiler starts again by itself once the fan works again; on the other models it stops and only starts again after a reset.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Code C1 264 on a Cerapur ZWB-4: the boiler restarts by itself once the fault has cleared, do not reset it.
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show C1?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code C1
The small number shown beside the code tells which.
The pressure switch opened during operation
Pressure switch open during operation
Fan speed too low
Fan failed
The boilers that show this code
What our technician checks
- The pressure switch and its connecting tubes (CeraclassExcellence ZWC-3, Eurostar ZWE-4)
- The flue
- The fan (extractor), its cable and plug, replaced if needed
- The fan, for dirt or a blockage (Cerapur ZWB-4)