Water pressure sensor or circuit board settings
Blocking: it retries by itself
On a Bluehelix HiTech RRT or a New Elite 60 the boiler no longer receives the signal of the water pressure sensor (sensor disconnected, wiring broken or sensor faulty); on a Bluehelix Alpha the water pressure switch or pressure sensor is configured wrongly or reports a pressure out of range; on a Bluehelix Top RRT a circuit board parameter is set wrongly. The boiler stops temporarily and restarts by itself once the cause has gone.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F47?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F47
The meaning depends on the boiler: find yours below.
Water pressure switch fault
Board parameter fault
No communication with the pressure transducer
System water pressure sensor fault
The boilers that show this code
What our technician checks
- The electrical connection, connector and wiring of the pressure sensor
- Bluehelix HiTech RRT: the pressure transducer, replaced if needed
- Bluehelix Alpha: the setting of parameter b04 (0 = pressure switch, default) and the pressure measured by the transducer
- Bluehelix Top RRT: the circuit board parameters, corrected if needed