Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Ferroli Fault code Ferroli
F37

System water pressure too low

Blocking: it retries by itself

The water pressure in the heating system is too low, or the pressure switch (the pressure sensor on a Bluehelix HiTech RRT) is disconnected or damaged. The boiler stops and restarts by itself once the pressure is restored.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. With the boiler cold, look at the pressure on the gauge or the display: it should be about 1 to 1.5 bar. Too low? Top up with the filling tap, as described in the boiler's manual, then close it again.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F37?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F37

The meaning depends on the boiler: find yours below.

F37

Incorrect system water pressure

Blocking: it retries by itself Bluehelix Alpha, Bluehelix HiTech RRT C, Bluehelix Top RRT K 50, Econcept 51 A, New Elite 60

The boilers that show this code

What our technician checks

  • Filling the system
  • The water pressure switch, or the pressure transducer on the Bluehelix HiTech RRT

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.