Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Ferroli Fault code Ferroli
A06

No flame after the ignition phase

Breakdown: the boiler is stopped

After the ignition phase the boiler detects no flame, for example because of the ionisation electrode, an unstable flame, a blocked flue or condensate trap (on an Econcept 51 A: six times in four minutes). The boiler locks out for safety and only restarts after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show A06?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code A06

The meaning depends on the boiler: find yours below.

A06

No flame after the ignition phase

Breakdown: the boiler is stopped Bluehelix Alpha, Bluehelix HiTech RRT C, Bluehelix Top RRT K 50
A06

No flame after the ignition phase (6 times in 4 min)

Breakdown: the boiler is stopped Econcept 51 A

What our technician checks

  • The ionisation electrode: position and deposits; replaced if needed
  • The burner
  • The chimney, flue ducts, air inlet and terminals (blockage)
  • The condensate trap, cleaned if needed
  • The calibration: full manual (Bluehelix Alpha) or AUTO SETUP (Bluehelix HiTech RRT)
  • Econcept 51 A: the gas valve Offset setting at minimum output
  • Bluehelix HiTech RRT: the mains gas pressure

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.