Water pressure too low
Blocking: it retries by itself
The water pressure in the system is too low (GB162: below 1.0 bar on standby or below 1.3 bar in operation), or, on floor-standing boilers, the pressure sensor is faulty. On the GB162, the boiler then limits its output, for both heating and hot water.
What you can do
- Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
- Check the water pressure: at least 1 bar, or the needle in the green zone of the pressure gauge. Too low? Top up with the boiler cold, the way your installer showed you.
- Do you often have to add water? Let us know: there is probably a leak or a faulty expansion vessel.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show H07?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
Choose a real expert
Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.
The variants of code H07
The small number shown beside the code tells which.
The operating pressure (heating system water pressure) is below 1.0 bar in standby or…
Water pressure too low
The boilers that show this code
What our technician checks
- The operating pressure, topped up to 2 bar, and bleeding of the system and the boiler
- The pressure sensor, replaced if necessary (floor-standing boilers)