Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Buderus Fault code Buderus
CY

Temperature sensor: impossible value

Breakdown: the boiler is stopped

The boiler reads an impossible value from a temperature sensor (return or flow): below -5 °C, above +130 °C, or an interrupted contact. For safety, the boiler locks out and will only restart after a reset.

What you can do

  1. Write down the code shown, the number next to it if there is one, and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show CY?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

Buderus

Choose a real expert

Ecowatt is an approved Buderus System Partner: factory training in Germany, direct access to spare parts, one contact.

The variants of code CY

The small number shown beside the code tells which.

CY
241

The contacts of the return temperature sensor are open (interrupted)

Breakdown: the boiler is stopped GB162
CY
566

Controller receives impermissible values from the return temperature sensor

Breakdown: the boiler is stopped GB212, KB192i, KB192i.2
CY
567

Controller receives impermissible values from the return temperature sensor

Breakdown: the boiler is stopped GB212, KB192i, KB192i.2
CY
573

Burner control unit receives impermissible values from the flow sensor

Breakdown: the boiler is stopped GB212, KB192i, KB192i.2
CY
574

Flow temperature sensor fault (short circuit)

Breakdown: the boiler is stopped GB212, KB192i, KB192i.2

The boilers that show this code

What our technician checks

  • The continuity of the connecting cable and the sensor
  • The sensor resistance, measured and compared with the manufacturer's table, and any short circuit in the cable
  • The wiring, connectors and operation of the return sensor, replaced if necessary (GB162)
  • The water pressure, bleeding and water flow rate of the system (GB162)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.