Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
W81

External control: signal too high or link lost

Blocking: it retries by itself

The meaning depends on the boiler: on a WTC-GW C series boiler, the remote control signal an external controller sends to input N1 is too high; on a Thermo Condens WTC-A or a WTC-OB, the boiler no longer communicates properly with remote control unit WCM-FS no. 1, and a WTC-OB then switches to its fallback functions. This is a warning: the boiler does not lock out and the message clears by itself once the cause is removed.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show W81?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code W81

The meaning depends on the boiler: find yours below.

W81

Control signal input N1 too high

Blocking: it retries by itself WTC-GW C (WEP)
W81

The WCM-FS#1 no longer transmits a correct setpoint

Blocking: it retries by itself Thermo Condens WTC-A (WCM)
W81

Communication problem with WCM-FS#1

Blocking: it retries by itself WTC-OB (WCM-OB)

What our technician checks

  • The signal on input N1 (WTC-GW C series)
  • The power supply and bus link of remote control unit WCM-FS no. 1 (WTC-A, WTC-OB)
  • The remote control unit (or the extension module), replaced if faulty

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.