Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
W80

External control: weak signal or lost link

Blocking: it retries by itself

The meaning depends on the boiler: on a WTC-GW C series boiler, the remote control signal an external controller sends to input N1 has been too low for about 15 minutes; on a Thermo Condens WTC-A, the WCM-KA cascade manager no longer sends a correct setpoint, and on a WTC-OB, communication with the cascade manager or the WCM-Sol module is disturbed. This is a warning: the boiler does not lock out and the message clears by itself once the cause is removed.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show W80?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code W80

The meaning depends on the boiler: find yours below.

W80

Control signal input N1 too low

Blocking: it retries by itself WTC-GW C (WEP)
W80

The WCM-KA cascade manager no longer sends a valid set point

Blocking: it retries by itself Thermo Condens WTC-A (WCM)
W80

Communication problem with the cascade manager or WCM-Sol.

Blocking: it retries by itself WTC-OB (WCM-OB)

What our technician checks

  • The signal on input N1 (WTC-GW C series)
  • The power supply and eBus link of the cascade manager (WTC-A, WTC-OB)
  • The WCM-KA cascade manager
  • The address set in parameter 12

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.