Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
W22

Flame lost during operation

Blocking: it retries by itself

The burner flame goes out while the boiler is running. It is a warning: a one-off (strong wind at the flue outlet, for example) needs no action, but a Thermo Condens WTC-A tries to start again and locks out (F21) if that fails, and a WTC-OB locks out (F22) after 5 warnings.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show W22?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code W22

The meaning depends on the boiler: find yours below.

W22

Flame loss during operation

Blocking: it retries by itself Thermo Condens WTC-A (WCM), WTC-GW C (WEP), WTC-GW/GB B (WEM)
W22

Flame loss during operation (after 5 alarms, the system locks out…

Blocking: it retries by itself WTC-OB (WCM-OB)

What our technician checks

  • The gas supply pressure
  • The ionisation electrode (SCOT electrode on the WTC-A) and its cable, replaced if needed
  • The burner surface, cleaned or replaced, and clean combustion air
  • The flue, its tightness and clear passage, and the condensate drain
  • The flue gas shut-off device, replaced if needed
  • The oil supply, the oil pump and the nozzle (WTC-OB)
  • The burner setting, mixing chamber, combustion tube and flame sensor (WTC-OB)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.