Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
W18

Gap between the two flow sensors

Blocking: it retries by itself

The two sensors that measure the flow water, the safety sensor and the flow sensor, read temperatures that are too far apart and the boiler stops. It is a warning that clears by itself, but on a WTC-GW or WTC-GB B series boiler or a WTC-GW C series boiler, the boiler locks out (F18) if it happens several times in a row.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show W18?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code W18

The meaning depends on the boiler: find yours below.

W18

Temperature differential flow (eSTB)/flow (VPT) too large

Blocking: it retries by itself WTC-GW C (WEP), WTC-GW/GB B (WEM)
W18

Temp. difference between safety thermostat/flow

Blocking: it retries by itself Thermo Condens WTC-A (WCM)

What our technician checks

  • The water flow through the boiler, increased if needed
  • Dirt or scale in the heat exchanger on the water side
  • The VPT flow temperature reading (parameter 1.2.1.7 on the B series, 1.3.1.7 on the C series)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.