Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Weishaupt Fault code Weishaupt
F62

Gas valve signal or BCC data fault

Breakdown: the boiler is stopped

On a WTC-GW or WTC-GB B series boiler and on a Thermo Condens WTC-A, the position signal of the gas valve (or the fan) is out of tolerance, for example because of the flue, the condensate drain, too low a gas pressure or the gas type setting; on a WTC-OB oil boiler, the data of the BCC coding key are in error. The boiler locks out and stops heating until our technician has found the cause.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show F62?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F62

The meaning depends on the boiler: find yours below.

F62

Gas valve or turbo motor position signal out of tolerance

Breakdown: the boiler is stopped WTC-GW/GB B (WEM)
F62

The position signal of the gas control is outside the tolerance band

Breakdown: the boiler is stopped Thermo Condens WTC-A (WCM)
F62

BCC data error

Breakdown: the boiler is stopped WTC-OB (WCM-OB)

What our technician checks

  • The ionisation electrode
  • The flue tightness and no recirculation of flue gas
  • The condensate drain
  • The gas connection pressure
  • The gas type setting
  • The fan, replaced if needed
  • The BCC coding key and its data transfer (WTC-OB)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.