Gas pressure too low or CO alarm
Blocking: it retries by itself
The gas pressure reaching the boiler is too low (Vitopend 100-W WH1D and A1JA); on a Vitodens 100-W B1HC this code comes from the gas pressure switch or the CO detector, if fitted, and the CO detector reacts to a carbon monoxide concentration that is too high. The burner stays blocked and the boiler stops heating as long as the cause is there, then it restarts by itself, without a reset; but if the CO detector has reacted, leave the room, air it and call us.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- If the CO detector has reacted: switch the boiler off, get everyone out, air the boiler room, close the doors of the living rooms and call us.
- Check that the gas supply valve is open; if it is, ask your gas supplier (on propane, check the tank level).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show 0A?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code 0A
The meaning depends on the boiler: find yours below.
The CO detector (if available) has tripped / The gas pressure switch (if available) has tripped
Gas supply pressure too low
What our technician checks
- The gas supply pressure and the gas pressure switch
- If the CO detector reacted (Vitodens 100-W B1HC): the heating system, with the cause of the CO leak repaired