Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Vaillant Fault code Vaillant
M.32

Heating water pressure low

Information: nothing to do

On a Vaillant aroTHERM VWL ../5 AS, aroTHERM plus VWL ../6 A, versoTHERM plus, recoCOMPACT exclusive or flexoTHERM/flexoCOMPACT exclusive heat pump, the water pressure in the heating circuit is low (below 0.7 bar), because of a leak, an air pocket or a faulty pressure sensor. This is a maintenance message: the heat pump is not in fault mode and keeps running normally, but if the pressure drops below 0.5 bar for more than a minute, fault F.22 is shown.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Read the water pressure on the display (menu, system monitor) and write it down.
  3. Call us: our technician will top up the heating water and look for the cause of the drop.

Nothing to do

This message belongs to the boiler's normal operation.

Call us
Vaillant

Choose a recognised installer

Ecowatt is a Vaillant installer: our group is on Vaillant's official list of installers.

The variants of code M.32

The meaning depends on the boiler: find yours below.

M.32

Heating circ. water pressure low

Information: nothing to do aroTHERM VWL ../5 AS, aroTHERM plus VWL ../6 A, recoCOMPACT exclusive VWL ../5, versoTHERM plus VWL ../5
M.32

Building circuit: low pressure

Information: nothing to do flexoTHERM exclusive VWF ../4

What our technician checks

  • The heating circuit's tightness, topping up and venting
  • The pressure sensor, its plug on the circuit board and the wiring harness, replaced if necessary

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.