Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Vaillant Fault code Vaillant
F.735

Evaporation temperature too high

Breakdown: the boiler is stopped

On a Vaillant aroTHERM VWL ../5 AS, aroTHERM plus VWL ../6 A, aroTHERM Split plus, aroTHERM VWL ../7.1 A and ../8.1 A, aroTHERM VWL ../8.1 A Q, versoTHERM plus, recoCOMPACT exclusive or flexoTHERM/flexoCOMPACT exclusive heat pump, the evaporation temperature is too high for the compressor to run: when heating, the heat source is too warm or supplies too much heat (for example a fan running fast); when cooling, it is the heating water. This is a refrigerant circuit fault for a technician to check; depending on the fault, the system may keep heating in emergency mode.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F.735?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.735

The meaning depends on the boiler: find yours below.

F.735

Evaporation temp. too high

Breakdown: the boiler is stopped aroTHERM VWL ../5 AS, aroTHERM plus VWL ../6 A, flexoTHERM exclusive VWF ../4, recoCOMPACT exclusive VWL ../5, versoTHERM plus VWL ../5
F.735

Evaporation temperature too high

Breakdown: the boiler is stopped aroTHERM Split plus VWL ../8.2 AS, aroTHERM VWL ../7.1 A, ../8.1 A, aroTHERM VWL ../8.1 A Q

What our technician checks

  • The system temperatures
  • The refrigerant quantity (overfilling)
  • The electronic expansion valve: does it reach its end stop? (sensor and actuator test)
  • The evaporation temperature sensor, depending on the 4-way valve position
  • The water flow when cooling and the air flow when heating
  • On a flexoTHERM: unwanted heat input, to be reduced or stopped
  • The compressor inlet sensor and the low-pressure sensor
  • On an aroTHERM VWL ../8.1 A Q: the brine return temperature (below 30 °C) and the circuit board

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.