Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Vaillant Fault code Vaillant
F.734

Condensing temperature too low

Breakdown: the boiler is stopped

On a Vaillant aroTHERM VWL ../5 AS, aroTHERM plus VWL ../6 A, aroTHERM Split plus, aroTHERM VWL ../7.1 A and ../8.1 A, aroTHERM VWL ../8.1 A Q, versoTHERM plus, recoCOMPACT exclusive or flexoTHERM/flexoCOMPACT exclusive heat pump, the refrigerant's condensing temperature is too low: the water in the heating circuit is too cold, outside the operating range, or the refrigerant quantity is wrong (too little, or too much on an aroTHERM VWL ../8.1 A Q). This is a refrigerant circuit fault for a technician to check; depending on the fault, the system may keep heating in emergency mode.

What you can do

  1. Write down the code shown and the heat pump model (on the rating plate).
  2. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show F.734?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code F.734

The meaning depends on the boiler: find yours below.

F.734

Condensation temp. too low

Breakdown: the boiler is stopped aroTHERM VWL ../5 AS, aroTHERM plus VWL ../6 A, flexoTHERM exclusive VWF ../4, recoCOMPACT exclusive VWL ../5, versoTHERM plus VWL ../5
F.734

Condensation temperature too low

Breakdown: the boiler is stopped aroTHERM Split plus VWL ../8.2 AS, aroTHERM VWL ../7.1 A, ../8.1 A, aroTHERM VWL ../8.1 A Q

What our technician checks

  • The electronic expansion valve: does it reach its end stop? (sensor and actuator test)
  • The compressor inlet sensor
  • The high-pressure and low-pressure sensors
  • The refrigerant quantity (technical data) and tightness
  • The 4-way valve: intermediate position or faulty switching
  • The heating circuit pressure sensor
  • On an aroTHERM VWL ../8.1 A Q: the return temperature (screed drying, cold building or cold cylinder?) and the circuit board
  • On a versoTHERM plus or recoCOMPACT exclusive: unwanted heat input, to be reduced or stopped

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.