Heating circuit pressure too low
Breakdown: the boiler is stopped
On a Vaillant aroTHERM VWL ../5 AS, aroTHERM plus VWL ../6 A, aroTHERM pure or flexoTHERM/flexoCOMPACT exclusive heat pump, the water pressure in the heating circuit has dropped below the minimum pressure (0.5 bar on a flexoTHERM), for example because of a leak, an air pocket or a faulty pressure sensor. The heat pump then switches off automatically: the heating water must be topped up and the cause found.
What you can do
- Write down the code shown and the heat pump model (on the rating plate).
- Read the water pressure shown on the display and write it down.
- Call us: our technician will top up the heating water.
- Does the pressure drop often? Tell us: the leak must be found.
Does your boiler show F.723?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.723
The meaning depends on the boiler: find yours below.
Building circuit: pressure too low
What our technician checks
- The tightness of the heating circuit
- Topping up and venting the circuit
- The plug-in connector on the circuit board and the wiring harness
- The pressure sensor, replaced if it does not work properly