Heating circuit water pressure too low
Breakdown: the boiler is stopped
On an aroTHERM VWL ..5/8.1 A Q or aroTHERM perform heat pump (VWZ AI /8 iQ module), the heating circuit water pressure is too low: pressure lost through a leak or an air pocket, or a faulty or wrongly set expansion vessel. It is a fault: below the minimum pressure the heat pump stops, and our technician needs to find the cause.
What you can do
- Write down the code shown and the heat pump model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F.6106?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F.6106
The meaning depends on the boiler: find yours below.
Heating circuit water pressure too low
What our technician checks
- The heating circuit and all its connections for leaks
- Topping up the heating water and bleeding the system
- The expansion vessel pre-charge pressure, reset if needed
- The expansion vessel, replaced if needed