Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Remeha Fault code Remeha
Code de défaut 2

Red light twice: maximum protection

Breakdown: the boiler is stopped

On the Tzerra M, the status light on the button flashes red twice: the boiler has locked out because the heat exchanger or the control unit has gone above its maximum temperature (codes E:12, E:41, read by our technician with a service tool). The causes range from too little water flow to an insufficient air supply or flue, or flue gas being drawn back in: the boiler must only be put back into service after our technician has checked it.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Smell of flue gas? Switch the boiler off, open the windows, leave the premises and call us.
  3. Do not reset the boiler: call us.

Does your boiler show Code de défaut 2?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code Code de défaut 2

The meaning depends on the boiler: find yours below.

Code de défaut 2

Maximum protection

Breakdown: the boiler is stopped Tzerra M

What our technician checks

  • Bleeding air from the heating system
  • The system water pressure
  • Circulation: direction, pump and valves, and fouling of the heat exchanger
  • The sensors: operation, fitting, wiring, replaced if faulty
  • The air supply
  • The flue (flue outlet)
  • The seals, to be replaced if flue gas is drawn back in

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.