Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Remeha Fault code Remeha
Code de défaut 1

Red light once: sensor fault

Breakdown: the boiler is stopped

On the Tzerra M, the status light on the button flashes red once: the boiler has locked out on a sensor, temperature or water flow fault (codes E:02 to E:11 and E:35, read by our technician with a service tool). It no longer heats until the cause is removed and the boiler has been reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check the system water pressure: at least 0.8 bar. Too low? Top up with water as your installer showed you.
  3. Reset the boiler once only.
  4. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show Code de défaut 1?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code Code de défaut 1

The meaning depends on the boiler: find yours below.

Code de défaut 1

Sensor error

Breakdown: the boiler is stopped Tzerra M

What our technician checks

  • The wiring and connection of the sensors
  • Operation and fitting of the sensors
  • The faulty sensor, replaced if needed
  • Bleeding air from the heating system
  • The system water pressure
  • Fouling of the heat exchanger
  • The direction of water flow: pump and valves

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.