Fan keeps running or wrong signal
Breakdown: the boiler is stopped
The fan keeps running when it should stop, or the boiler gets a wrong speed signal from it: broken connection, faulty fan electronics or strong natural draught in the chimney. The boiler goes into lockout (the digits flash) and only restarts after a reset.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Reset the boiler once only.
- If the code comes back, do not keep trying and do not take anything apart: call us.
Does your boiler show 29?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code 29
The meaning depends on the boiler: find yours below.
The fan runs continuously or the speed signal is not correct
The fan does not stop or wrong signal
The fan keeps running or the signal is incorrect
The fan does not stop
The boilers that show this code
What our technician checks
- The fan cables and connectors, at the fan end and at the control unit end
- W40-m and W60-m Eco: the fan's electrical connections, swapped or broken
- The fan electronics, fan replaced if they are faulty
- The chimney's natural draught, if it is too strong