Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Remeha Fault code Remeha
18

Flow temperature too high

Breakdown: the boiler is stopped

The water leaving the boiler for the heating has become too hot, usually because it is not circulating well: too little flow, air in the system or water pressure too low. The boiler goes into lockout (the digits flash) and only restarts after a reset.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Quinta 25s, 30s, 28c or 35c: look at the water pressure on the gauge under the boiler. Below 1.5 bar, top up the water with the boiler cold (below 40 °C), as your installer showed you.
  3. Reset the boiler once only.
  4. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show 18?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code 18

The meaning depends on the boiler: find yours below.

18

Temperature too high

Breakdown: the boiler is stopped Quinta 115, Quinta 25/30s 28/35c, Quinta 45/65, Quinta 85
18

Flow temperature too high

Breakdown: the boiler is stopped Gas 210 Eco, Gas 310 Eco, Gas 610 Eco
18

Max. water temp.

Breakdown: the boiler is stopped W40/60-m Eco

The boilers that show this code

What our technician checks

  • The water flow through the boiler and the system
  • Bleeding the air out of the system
  • The flow and return sensors, their resistance measured
  • The system water pressure (at least 0.8 bar)

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.