Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Fault code Oertli
D09

Hot water sensor fault

Breakdown: the boiler is stopped

On a GMR 3000 or GMR 5000 Condens, the controller no longer gets a valid reading from the hot water sensor, because of a bad connection or a faulty sensor. Hot water heating is no longer ensured: the charging pump runs and the tank is charged at the boiler temperature.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Reset the boiler once only.
  3. If the code comes back, do not keep trying and do not take anything apart: call us.

Does your boiler show D09?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code D09

The meaning depends on the boiler: find yours below.

D09

Domestic hot water sensor fault

Breakdown: the boiler is stopped GMR 3000 Condens, GMR 5000 Condens

The boilers that show this code

What our technician checks

  • The sensor connection; if it was removed on purpose, erasing it from the SCU board memory
  • The sensor wiring and connectors
  • How the sensor is fitted
  • The sensor's resistance (ohms), replaced if needed

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.