Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Fault code Oertli
B01

Maximum flow temperature exceeded

Blocking: it retries by itself

The water leaving the boiler for the heating has gone above its maximum temperature, because the water is not flowing enough through the system. On the GMR 3000 and GMR 5000 Condens it is a blocking message: the boiler stops and starts again by itself once the cause is gone.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check that the radiator valves are open.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show B01?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code B01

The meaning depends on the boiler: find yours below.

B01

Maximum flow temperature exceeded

Blocking: it retries by itself GMR 3000 Condens, GMR 5000 Condens

The boilers that show this code

What our technician checks

  • Water circulation: direction, pump and valves

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.