Skip to Content
+32 15 62 70 80 info@ecowatt.be Mon-Thu 07:30-17:00, Fri 07:30-13:30 Request a repair
Repair
Fault code Oertli
B22

Flame lost during operation

Blocking: it retries by itself

The burner flame went out while the boiler was running: the boiler no longer measures an ionisation current, the signal that confirms the flame. On the GMR 3000 and GMR 5000 Condens it is a blocking message: the boiler stops and starts again by itself once the cause is gone; if the flame goes out more than 5 times in 24 hours, it moves to fault L36.

What you can do

  1. Write down the code shown and the boiler model (on the rating plate).
  2. Check that the boiler's gas tap is open.
  3. Does the code stay on or come back? Do not take anything apart: call us.

Does your boiler show B22?

Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.

* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.

The variants of code B22

The meaning depends on the boiler: find yours below.

B22

Flame loss during operation

Blocking: it retries by itself GMR 3000 Condens, GMR 5000 Condens

The boilers that show this code

What our technician checks

  • Purging the gas line
  • The gas tap and the gas supply pressure
  • Operation and setting of the gas valve unit
  • The air intake and flue gas ducts (blockage)
  • Any flue gas recirculation

Related codes

From the manufacturer's service manuals for Belgium. Each appliance has its own features: if in doubt, call us.