Pressure switch, settings or slightly high pressure
Blocking: it retries by itself
The meaning depends on the boiler: on a Bluehelix Alpha the water pressure switch or pressure sensor is configured wrongly or reports a pressure out of range; on a Bluehelix Top RRT a circuit board parameter is set wrongly; on a Bluehelix HiTech RRT the water pressure is slightly too high, which only shows in the alarm menu. On the HiTech RRT the boiler keeps heating at reduced power; on the other two it stops temporarily and restarts by itself once the cause has gone.
What you can do
- Write down the code shown and the boiler model (on the rating plate).
- Does the code stay on or come back? Do not take anything apart: call us.
Does your boiler show F21?
Repair visit: 180 € excl. VAT (190.80 € incl. 6 % VAT*), first hour included, parts excluded.
* 6 % VAT: work on a private home more than 10 years old, invoiced to a private person. Without a written objection within a month of the invoice, you confirm that these conditions are met; otherwise the VAT is 21 % and the responsibility is yours.
The variants of code F21
The meaning depends on the boiler: find yours below.
Water pressure switch fault
Board parameter fault
System pressure slightly high (visible only in the Alarm menu)
What our technician checks
- Bluehelix Alpha: the setting of parameter b04 (0 = pressure switch, default) and the pressure measured by the transducer
- Bluehelix Top RRT: the circuit board parameters, corrected if needed
- Bluehelix HiTech RRT: the system pressure, brought back to 1 to 1.5 bar by partial draining
- Bluehelix HiTech RRT: the expansion vessel